Gyre Advanced Controller Firmware Updates

Below you will find the latest firmware updates and tools for your Gyre Advanced Controller.  Always read and follow the instructions and guides prior to updating your firmware.  Not following the directions can potentially “brick” your controller and render it inoperable.    WARNING Please be sure to install ONLY the correct firmware for your controller.  Not doing so will “brick” your controller and render it...

Read More

Maxspect Gyre 200 Series: Advanced Controller Setup

The second generation Maxspect Gyre plus its mind blowing Advanced Controller is only a few days away from hitting the market.   W e are happy to report that Maxspect will soon release their Advanced Series Controller along with the second generation of Gyre pumps. The 200 Series Gyre has all the great features you have come to expect from a Maxspect Gyre pump as well as new stronger propellers and bushings, a longer more durable...

Read More

Maxspect Gyre: Step-by-Step Assembly & Advanced Troubleshooting

In this episode of [CVtv], Carlos Chacon takes you step-by-step on how to properly assemble the Maxspect Gyre pump! I n this episode of [CVtv], Carlos Chacon takes you step-by-step on how to properly assemble the Maxspect Gyre pump and covers some advanced troubleshooting.   To assemble the gyre, we must make sure that all motor block bushings are installed correctly. Although the bushings are usually preassembled and installed, here...

Read More

Maxspect Shows Off the Gyre XF-180 at MACNA 2015

In this episode of [CVtv], Maxspect gives us a peak at the new Gyre XF-180 Flow Pump and continues to amazes us with their innovation and design! I n this episode of [CVtv], Maxspect continues to amazes us with their innovation, design and efficiency.   The Gyre XF-180 is the bigger brother of the XF-180.  It is about 2″ larger than the XF-150 and it can conservatively push more than 6,000 gallons of water per hour.  The pump...

Read More

IceCap Gyre Interface Module: Sync and Anti-Sync

Did you know you can program two separate Maxspect Gyre pumps to work together and create more intricate flow patters? Stay tuned to find out! I n this final episode of our IceCap Gyre Interface Module video series, we will create an advanced program that will allow us to synchronized two Maxspect Gyre pumps using two IceCap modules. We will begin by placing two pumps horizontally on each side of our tank. Then we will alternate flow...

Read More

IceCap Gyre Interface Module: Alternating Gyre Mode

Do you want to unlock the full potential of your Maxspect Gyre pump and run it in both forward and reverse directions? I n this video, Carlos of CoralVue demonstrates how to program your Neptune System’s Apex controller to take advantage of the IceCap module and make your Maxspect Gyre run in Alternating Gyre Mode. By the end of this video we will have covered how to: Set out pump to switch directions and pulse at two different speeds...

Read More